80209C_MHW_850-1650-1850_02-2020_ENG_pag. 149
4.21.5. RECP.N - Number of parameters recipes
Acronym Scrolling message Submenu Attributes
RECP.N NUM OF PARAMETER RECIPES EN.FUN R W
The parameter shows and sets the number of parameters recipes for which the template is defined via GF_eXpress.
If the parameter is “0” the parameters recipes are disabled.
Unit of measurement: Number
Options: 0...5
4.21.6. ALRM.N - Number of alarms enabled
Acronym Scrolling message Submenu Attributes
ALRM.N NUM OF ENABLE ALARMS EN.FUN R W
The parameter shows and sets the number of alarms enabled.
No alarm is enabled if the parameter equals “0”.
Unit of measurement: Number
Options: 0...4
4.21.7. ON.OF - Enabling software on/off
Acronym Scrolling message Submenu Attributes
On.OF SOFTWARE ON/OFF ENABLE EN.FUN R W
The parameter shows and sets enabling of on/off of the controller’s software.
The software ON-OFF function is explained in detail in paragraph “5.8. Switching the software on/off” on page <?>.
Unit of measurement: -
Options: ENABL = Controller software on/off enabled
DISAB = Controller software on/off disabled
4.21.8. DIG - Defining type of digital inputs
Acronym Scrolling message Submenu Attributes
dIG DIGITAL INPUT TYPE EN.FUN R W
The parameter shows and sets the type of digital inputs.
Unit of measurement: -
Options: NPN = NPN digital inputs or voltage-free contact
PNP = PNP digital inputs
4.21.9. T.SAMP - Main and Auxiliary input sample time
Acronym Scrolling message Submenu Attributes
T.SAMP MAIN INPUT SAMPLE TIME EN.FUN R W
The parameter shows and sets the main and auxiliary input sample time.
Unit of measurement: Milliseconds
Options: 60
120
To Next Page
Loading...
Need help?
General
