INVT EC160 User Manual

User manual of EC160 elevator intelligent integrated machine EC160 configuration
3
No. Type Function name Function instruction Remarks
door lock closes, the overload switch will
act and the elevator opens the door
reversely; after the door lock closes,
overload protection will cancel.
13
Overspeed
protection
Ensure the running speed is in the safe
range.
Standard
14
Bus voltage
protection
Protect and stop when bus undervoltage or
overvoltage
Standard
15
Phase loss
protection
Protect and stop when input or output
phase loss
Standard
16
To-ground
short-circuit
detection
Inspect U, V and W when powering on Standard
17
Converting
overheating
protection
Protect and stop when converting module
overheating
Standard
18
Rectification
overheating
protection
Protect and stop when rectification module
overheating
Standard
19
Motor overheating
protection
If the thermal protection signal acts, the
elevator will stop and open at the nearest
leveling position. The elevator will begin to
work after the time set by the thermal
protection delay
Standard
20
Opening protection
in non-door area
The system forbids opening in non-door
area
Standard
21
Adhesion protection
of the door switch
Protect, open the door at lower limit arrival
when the door switch is adhesive
Standard
22
Door beam
protection
In the process of closing, if the door is
blocked, it will open the door
Note: The function RSE will cancel
automatically in fire operation and the SE is
effective (RSE is the front door beam for
the single door operator).
Standard

INVT EC160 Specifications

General

Brand	INVT
Model	EC160
Category	Control Systems
Language	English