Using the J-Web Interface
To perform basic configuration for the 1-Port ADSL2 Mini-PIM and to configure network
interfaces for the services gateway using the J-Web interface:
1. In the J-Web interface, select Configure>Interfaces>Ports.
The Interfaces page displays and lists the network interfaces present on the services
gateway, along with configuration information (if configured).
2. To configure properties for a network interface (Mini-PIM), select the interface name
( for example at-1/0/0), and click Edit.
3. To use the port on the Mini-PIM, you must assign it to a security zone other than the
Null zone. Optionally, you can also assign the port an IP address (for example,
192.168.3.1/24). Enter or select the following settings:
a. Select Configure>Security>Zones.
b. Add or select a security zone other than Null; for example, Trust.
c. For host inbound traffic, set the following:
•
System Services=Allow All
•
Protocols=Allow All
d. Click OK to save changes, and click Commit to apply the configuration and other
pending changes.
4. To use the port on the Mini-PIM, you must also set security policies. Select the following
settings:
a. Select Configure>Security>Policy>Apply Policy.
b. Set Policy Action: Default Policy Action=Permit-All.
c. Click OK to save changes, and click Commit to apply the configuration and other
pending changes (if any).
See the Junos OS Network Interfaces Configuration Guide for more details.
Using the CLI
To perform basic configuration for the 1-Port ADSL2+ Mini-PIM and to configure network
interfaces for the services gateway with the CLI:
•
Verify that the serial interface is installed on the device:
show chassis hardware
•
Verify the status of the interface:
show interfaces terse
•
Assign the port an IP address:
Copyright © 2015, Juniper Networks, Inc.210
SRX Series Services Gateways for the Branch Physical Interface Modules Reference
To Next Page
Loading...
Need help?
General
