•
Phillips (+) screwdrivers, numbers 1 and 2
•
Blank panels (if no component will be installed)
Related
Documentation
Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the
SRX Series Services Gateway on page 255
•
• Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services
Gateway on page 256
• Installing a Double-High, Double-Wide Gigabit-Backplane Physical Interface Module
on the SRX Series Services Gateway on page 258
• Removing a Gigabit-Backplane Physical Interface Module from the SRX Series Services
Gateway on page 260
Preventing Electrostatic Discharge Damage to the SRX Series Services Gateway
Many services gateway hardware components are sensitive to damage from static
electricity. Some components can be impaired by voltages as low as 30 V. You can easily
generate potentially damaging static voltages whenever you handle plastic or foam
packing material or if you move components across plastic or carpets. Observe the
following guidelines to minimize the potential for electrostatic discharge (ESD) damage,
which can cause intermittent or complete component failures:
•
Always use an ESD wrist strap or ankle strap, and verify that it is in direct contact with
your skin.
CAUTION: For safety, periodically check the resistance value of the ESD
strap. The measurement must be in the range of 1 to 10 Mohms.
•
When handling any component that is removed from the chassis, verify that the
equipment end of your ESD strap is attached to one of the ESD points on the chassis.
•
Avoid contact between the component and your clothing. ESD voltages emitted from
clothing can damage components.
•
When removing or installing a component, always place it component-side up on an
antistatic surface, in an antistatic card rack, or in an electrostatic bag. See
Figure 40 on page 247. If you are returning a component, place it into an electrostatic
bag before packing it.
Copyright © 2015, Juniper Networks, Inc.246
SRX Series Services Gateways for the Branch Physical Interface Modules Reference
To Next Page
Loading...
Need help?
General
