Table 37: 1-Port T1/E1 Mini-PIM Physical Specifications (continued)
ValueDescription
5% to 90% noncondensingRelative humidity
Related
Documentation
1-Port T1/E1 Mini-Physical Interface Module Overview on page 65•
• 1-Port T1/E1 Mini-Physical Interface Module Network Interface Specifications on page 23
• 1-Port T1/E1 Mini-Physical Interface Module Supported Standards on page 68
• 1-Port T1/E1 Mini-Physical Interface Module Key Features on page 66
• 1-Port T1/E1 Mini-Physical Interface Module LEDs on page 67
• 1-Port T1/E1 Mini-Physical Interface Module Supported Loopback Diagnostics on page 68
• 1-Port T1/E1 Mini-Physical Interface Module Basic Configuration on page 215
1-Port T1/E1 Mini-Physical Interface Module LEDs
The 1-Port T1/E1 Mini-Physical Interface Module (Mini-PIM) has three LEDs.
Table 38 on page 67 describes the LED states.
Table 38: 1-Port T1/E1 Mini-PIM LED States
DescriptionStateColorLED
Indicates that there is a local or remote
alarm; device has detected a failure.
OnYellowALARM
Indicates that there are no alarms or failures.Off
Indicates that a loopback or line state is
detected.
OnYellowLOOPBACK
Indicates that the loopback is not active.Off
Indicates that the Mini-PIM link is up.OnGreenCD (Carrier
Detector)
Indicates that carrier detect is not active.Off
Related
Documentation
1-Port T1/E1 Mini-Physical Interface Module Overview on page 65•
• 1-Port T1/E1 Mini-Physical Interface Module Hardware Specifications on page 66
• 1-Port T1/E1 Mini-Physical Interface Module Network Interface Specifications on page 23
• 1-Port T1/E1 Mini-Physical Interface Module Supported Standards on page 68
• 1-Port T1/E1 Mini-Physical Interface Module Key Features on page 66
• 1-Port T1/E1 Mini-Physical Interface Module Supported Loopback Diagnostics on page 68
67Copyright © 2015, Juniper Networks, Inc.
Chapter 9: 1-Port T1/E1 Mini-Physical Interface Module
To Next Page
Loading...
Need help?
General
