Juniper SRX Series User Manual

•
Protocols=Allow All
d. Click OK to save changes, and click Commit to apply the configuration and other
pending changes (if any).
7. To use the port on the GPIM, you must also set security policies. Select the following
settings:
a. Select Configure>Security>Policy>Apply Policy.
b. Set Policy Action: Default Policy Action=Permit-All.
c. Click OK to save changes, and click Commit to apply the configuration and other
pending changes (if any).
For advanced configuration information, see the Junos OS Network Interfaces Configuration
Guide.
Using the CLI to Configure the CT1 Interface
To perform basic configuration for the Dual CT1/E1 GPIM (for the CT1 interface) and to
configure network interfaces for the services gateway with the CLI:
NOTE: You must configure the parent CT1 interface before you can configure
the child T1 interface.
•
Verify that the Dual CT1/E1 GPIM is installed on the services gateway:
show chassis hardware
•
Verify the FPC status of the interface:
show chassis fpc
•
Configure the parent CT1 interface with no partitioning:
set interfaces ct1-3/0/0 no-partition interface-type t1
•
Configure the child T1 interface and assign an IP address:
set interfaces t1-3/0/0 unit 0 family inet address ip4–address/prefix
•
Assign MTU values to the child T1 interface:
set interfaces t1-3/0/0 unit 0 mtu mtu values
•
Configure a security zone for the child T1 interface and set the configuration for host
inbound traffic services and protocols:
set security zones security-zone trust interfaces t1-3/0/0 host-inbound-traffic
system-services all
set security zones security-zone trust interfaces t1-3/0/0 host-inbound-traffic protocols
all
•
Set security policies:
Copyright © 2015, Juniper Networks, Inc.236
SRX Series Services Gateways for the Branch Physical Interface Modules Reference

Juniper SRX Series Specifications

General

Brand	Juniper
Model	SRX Series
Category	Gateway
Language	English