Juniper SRX Series User Manual

Tx clock: non-invert
Line encoding: nrz
Packet Forwarding Engine configuration:
Destination slot: 4
CoS information:
Direction : Output
CoS transmit queue Bandwidth Buffer Priority
Limit
% bps % usec
0 best-effort 95 7600000 95 0 low
none
3 network-control 5 400000 5 0 low
none
4. Assign the interface an IP address:
[edit]
user@host# set interfacesinterface-nameunit 0 family inet addressinterface
address/destination prefix
5. Add or select a security zone:
[edit]
user@host# set security zones security-zonezone-name
interfacesinterface-namehost-inbound-traffic system-services all
6. Add or select security zones for host inbound traffic protocol options:
[edit]
user@host# set security zones security-zonezone-nameinterfacesinterface-name
host-inbound-traffic protocols all
7. Set security policies:
[edit]
user@host# set security policiespolicy-name
Related
Documentation
8-Port Serial GPIM Overview on page 97•
• 8-Port Serial GPIM Hardware Specifications on page 99
• 8-Port Serial GPIM Components on page 98
• 8-Port Serial GPIM Key Features on page 99
• 8-Port Serial GPIM LEDs on page 100
• 8-Port Serial GPIM Interface Cables on page 161
• 8-Port Serial GPIM Interface Specifications on page 26
16-Port Gigabit Ethernet XPIM Basic Configuration
To enable the 16-Port Gigabit Ethernet XPIM installed on your SRX Series Services
Gateway, you must configure its properties. You can perform the same configuration
tasks using the J-Web interface or the CLI configuration editor. In addition, you can
configure a wider variety of options that are encountered less frequently.
Copyright © 2015, Juniper Networks, Inc.232
SRX Series Services Gateways for the Branch Physical Interface Modules Reference

Juniper SRX Series Specifications

General

Brand	Juniper
Model	SRX Series
Category	Gateway
Language	English