You can perform the configuration tasks for this using either the J-Web interface or the
CLI.
•
Using the J-Web Interface on page 218
•
Using the CLI on page 218
Using the J-Web Interface
To perform basic configuration for the 1-Port VDSL2 (Annex A) Mini-Physical Interface
Module (Mini-PIM) and to configure network interfaces for the services gateway using
the J-Web interface:
1. In the J-Web interface, select Configure>Interfaces>Ports.
The Interfaces page displays and lists the network interfaces present on the services
gateway, along with configuration information (if configured).
2. To configure properties for a network interface (Mini-PIM), select the interface name
(pt-1/0/0), and click Edit.
3. To use the port on the Mini-PIM, you must assign it to a security zone other than the
Null zone. Optionally, you can also assign the port an IP address (for example,
192.168.3.1/24). Enter or select the following settings:
a. Select Configure>Security>Zones.
b. Add or select a security zone other than Null; for example, Trust.
c. For host inbound traffic, set the following:
•
System Services=Allow All
•
Protocols=Allow All
d. Click OK to save changes, and click Commit to apply the configuration and other
pending changes.
4. To use the port on the Mini-PIM, you must also set security policies. Select the following
settings:
a. Select Configure>Security>Policy>Apply Policy
b. Set Policy Action: Default Policy Action=Permit-All
c. Click OK to save changes, and click Commit to apply the configuration and other
pending changes (if any).
For more information, in the J-Web interface, select Configure>Interfaces and click Help.
Using the CLI
To perform basic configuration of the 1-Port VDSL2 (Annex A) Mini-PIM and to configure
network interfaces for the services gateway with the CLI:
Copyright © 2015, Juniper Networks, Inc.218
SRX Series Services Gateways for the Branch Physical Interface Modules Reference
To Next Page
Loading...
Need help?
General
