EasyManuals Logo
Home>Juniper>Gateway>SRX Series

Juniper SRX Series User Manual

Juniper SRX Series
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #237 background imageLoading...
Page #237 background image
set security policies default-policy permit-all
See the Junos OS Network Interfaces Configuration Guide for more details.
Related
Documentation
1-Port DOCSIS Mini-Physical Interface Module Overview on page 51•
• 1-Port DOCSIS Mini-Physical Interface Module Key Features on page 52
• 1-Port DOCSIS Mini-Physical Interface Module Supported Standards on page 55
• 1-Port DOCSIS Mini-Physical Interface Module Hardware Specifications on page 53
• 1-Port DOCSIS Mini-Physical Interface Module Network Interface Specifications on
page 22
• 1-Port DOCSIS Mini-Physical Interface Module LEDs on page 53
1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Basic Configuration
To enable the 1-Port G.SHDSL Mini-Physical Interface Module (Mini-PIM) installed on
the SRX Series Services Gateway, you must configure its properties. You can perform
the same configuration tasks using J-Web or the CLI. In addition, you can configure a
wider variety of options that are encountered less frequently.
To perform basic perform basic configuration of the 1-Port G.SHDSL Mini-PIM and
configure network interfaces for the services gateway with the CLI:
•
Verify that the 1-Port G.SHDSL Mini-PIM is installed on the services gateway:
show chassis hardware
•
Verify the status of the interface:
show interfaces terse
•
Assign the port an IP address:
set interface at-1/0/0 unit 0 family inet address interface address/destination prefix
•
Add or select a security zone, for example, Zone1:
set security zones security-zone zone1 interfaces at-1/0/0.0 host-inbound-traffic
system-services all
•
Add or select a security zones for host inbound traffic protocol options:
set security zones security-zone zone1 interfaces at-1/0/0.0 host-inbound-traffic protocols
all
•
Set security policies:
set security policies default-policy permit-all
Related
Documentation
1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Overview on page 57•
• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Supported Standards on page 60
• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Operating Modes on page 241
213Copyright © 2015, Juniper Networks, Inc.
Chapter 25: Configuring Mini-Physical Interface Modules

Table of Contents

Other manuals for Juniper SRX Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX Series and is the answer not in the manual?

Juniper SRX Series Specifications

General IconGeneral
BrandJuniper
ModelSRX Series
CategoryGateway
LanguageEnglish

Related product manuals