EasyManuals Logo
Home>Juniper>Gateway>SRX Series

Juniper SRX Series User Manual

Juniper SRX Series
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #82 background imageLoading...
Page #82 background image
• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Key Features on page 58
• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Hardware Specifications on
page 59
• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module LEDs on page 59
1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Key Features
The 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module (Mini-PIM) provides the
following key features:
•
2-wire (4-port 2-wire) mode, 4-wire (2-port 4-wire) mode, and 8-wire (1-port 8-wire)
mode support
•
Annex A, Annex B, Annex F, and Annex G support
•
Virtual circuits per Mini-PIM (8 maximum)
•
Asynchronous Transfer Mode (ATM) over G.SHDSL framing
•
ATM class-of-service (CoS) support
•
ATM Operation, Administration, and Maintenance (OAM) support
•
Dying Gasp support
Dying Gasp is the ability of the device to automatically notify the service provider digital
subscriber line access multiplexer (DSLAM) if a power failure occurs. The customer
premises equipment (CPE) sends a message to the DSLAM, which indicates that a
line was lost because of loss in CPE power.
•
Wetting current support
Wetting current is a small amount of electrical current sent from the central office
(CO) over the copper pair to the CPE to prevent the erosion of the copper wires. Some
service providers also use wetting current as a method for identifying cable pairs, and
they therefore need to recognize and receive wetting current. Additionally, wetting
current can be used to power devices such as repeaters and low power devices.
•
Noise margin support
•
Point-to-Point Protocol over ATM and PPPoE over ATM encapsulation support
•
Local loopback mode support
Related
Documentation
1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Overview on page 57•
• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Supported Standards on page 60
• MTU Default and Maximum Values for Physical Interface Modules on page 12
• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Operating Modes on page 241
• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Hardware Specifications on
page 59
• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module LEDs on page 59
Copyright © 2015, Juniper Networks, Inc.58
SRX Series Services Gateways for the Branch Physical Interface Modules Reference

Table of Contents

Other manuals for Juniper SRX Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX Series and is the answer not in the manual?

Juniper SRX Series Specifications

General IconGeneral
BrandJuniper
ModelSRX Series
CategoryGateway
LanguageEnglish

Related product manuals