Juniper SRX Series User Manual

PIC 0 Online 4x GE Base PIC
Slot 3 Online FPC
PIC 0 Online 8x Sync Serial gPIM
Slot 6 Online FPC
PIC 0 Online 24x GE POE gPIM
3. Verify that the serial network interface that you want to configure on the GPIM is up:
user@host> show interfaces terse
The following sample output shows that the serial network interface you are
configuring is up:
root@srx-650-a> show interfaces se-4/0/* terse
Interface Admin Link Proto Local Remote
se-4/0/0 up up
se-4/0/1 up up
se-4/0/2 up up
se-4/0/3 up up
se-4/0/4 up up
se-4/0/5 up up
se-4/0/6 up up
se-4/0/7 up up
The following sample output shows extensive details of se-4/0/0 on the interface:
root@srx-650-a> show interfaces se-4/0/0 extensive Physical interface: se-4/0/0,
Enabled, Physical link is Up
Interface index: 150, SNMP ifIndex: 773, Generation: 177
Type: Serial, Link-level type: PPP, MTU: 1504, Maximum speed: 8mbps
Device flags : Present Running
Interface flags: Point-To-Point Internal: 0x0
Link flags : Keepalives
Hold-times : Up 0 ms, Down 0 ms
CoS queues : 8 supported, 8 maximum usable queues
Last flapped : 2012-03-01 11:07:13 PST (10:57:02 ago)
Statistics last cleared: Never
Traffic statistics:
Input bytes : 0 0 bps
Output bytes : 0 0 bps
Input packets: 0 0 pps
Output packets: 0 0 pps
Input errors:
Errors: 3, Drops: 0, Framing errors: 3, Runts: 0, Giants: 0,
Policed discards: 0, Resource errors: 0
Output errors:
Carrier transitions: 1, Errors: 0, Drops: 0, MTU errors: 0,
Resource errors: 0
Serial media information:
Line protocol: eia530a
Resync history:
Sync loss count: 0
Data signal:
Rx Clock: OK
Control signals:
Local mode: DCE
To DTE: CTS: up, DCD: up, DSR: up
From DTE: DTR: up, RTS: up
DCE loopback override: Off
Clocking mode: internal
Loopback: none
231Copyright © 2015, Juniper Networks, Inc.
Chapter 26: Configuring Gigabit-Backplane Physical Interface Modules

Juniper SRX Series Specifications

General

Brand	Juniper
Model	SRX Series
Category	Gateway
Language	English