Juniper SRX Series User Manual

Table 3: SRX Series Services Gateway Interface Port Number
Examples (continued)
Interface Number ExampleInterface Type
ge–3/0/0 through ge–3/0/7
NOTE: The SRX550 and the SRX650 Services
Gateways have high gigabit and non-high
gigabit slots.
•
In the high gigabit slot, you can achieve a
maximum bandwidth of 8 gigabits.
•
In the non-high gigabit slot, you can achieve
a maximum bandwidth of 1 gigabit.
8-Port Gigabit Ethernet small form-factor
pluggable (SFP) XPIM
•
SRX550—ge–3/0/0
•
SRX650—ge–2/0/0
NOTE: When installing the 16–Port Gigabit
Ethernet XPIM, which uses 2 slots, you must
install it in the 10–Gigabit or 20–Gigabit GPIM
slots:
•
SRX550 Services Gateway—Slots 3 and 6,
which refer to the right side bottom two
standard slots (slots 3 and 4) ) and the right
side top two standard slots (6 and 8).
•
SRX650 Services Gateway—Slots 2 and 6,
which refer to the bottom four standard slots
(slots 1, 2, 3, and 4), and the top four
standard slots (slots 5, 6, 7, and 8).
16-Port Gigabit Ethernet XPIM
•
SRX550—ge-6/0/0
•
SRX650—ge-2/0/0
NOTE: When installing the 24–Port Gigabit
Ethernet XPIM, which uses 4 slots, you must
install it in the 20–Gigabit GPIM slots:
•
SRX550 Services Gateway—Slot 6.
•
SRX650 Services Gateway—Slots 2 and 6.
24-Port Gigabit Ethernet XPIM
•
SRX550 Services Gateway—xe–3/0/0
•
SRX650 Services Gateway—xe–2/0/0,
xe–2/0/1, or
xe–6/0/0, xe–6/0/1
NOTE: Represents two fiber and two copper
ports; user configured. Must be installed in one
of the following GPIM slots:
•
SRX550 Services Gateway—Slot 3 for
10-Gigabit GPIM and slot 6 for 20-Gigabit
GPIM.
•
SRX650 Services Gateway—Slots 2 or 6.
2-Port 10-Gigabit Ethernet XPIM
5Copyright © 2015, Juniper Networks, Inc.
Chapter 1: SRX Series Services Gateway Interface Modules Support

Juniper SRX Series Specifications

General

Brand	Juniper
Model	SRX Series
Category	Gateway
Language	English