Configuration Guide Configuring RMON
4 Configuring RMON
4.1 Overview
The Remote Network Monitoring (RMON) aims at resolving problems of managing local area networks (LANs) and remote
sites by using one central point. In RMON, network monitoring data consists of a group of statistics and performance
indicators, which can be used for monitoring the network utilization, so as to facilitate network planning, performance
optimization, and network error diagnosis.
RMON is mainly used by a managing device to remotely monitor and manage managed devices.
The RMON function is not supported on AP110-W or AP120-W.
Protocols and Standards
STD 0059 / RFC 2819: Remote Network Monitoring Management Information Base
RFC4502: Remote Network Monitoring Management Information Base Version 2
RFC 3919: Remote Network Monitoring (RMON) Protocol Identifiers for IPv6 and Multi Protocol Label Switching (MPLS)
RFC 3737: IANA Guidelines for the Registry of Remote Monitoring (RMON) MIB Modules
RFC 3434: Remote Monitoring MIB Extensions for High Capacity Alarms
RFC 3395: Remote Network Monitoring MIB Protocol Identifier Reference Extensions
RFC 3287: Remote Monitoring MIB Extensions for Differentiated Services
RFC 3273: Remote Network Monitoring Management Information Base for High Capacity Networks
RFC 2896: Remote Network Monitoring MIB Protocol Identifier Macros
RFC 2895: Remote Network Monitoring MIB Protocol Identifier Reference
4.2 Applications
Collecting Statistics on Information of
a Monitored Interface
Applies four functions of RMON to an interface to monitor the network communication
of the interface.
4.2.1 Collecting Statistics on Information of a Monitored Interface
Scenario
The RMON Ethernet statistics function is used to monitor accumulated information of an interface, the history statistics
function is used to monitor the packet count of an interface within each monitoring interval, and the alarm function is used to
immediately acquire packet count exceptions of an interface. The following figure shows the networking topology.