Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring FPM
 The loose TCP status check function is required on the standby device in a scenario such as active/standby switchover.
Command Syntax
ip session tcp-loose
Parameter
Description
Command Mode
Global configuration mode
Configuration Usage
Use the no form of this command to restore the default configuration.
2.4.6.4 Verification
 Use the show run command to check whether the configuration includes ip session tcp-loose. If no, the loose TCP
status check function is disabled.
2.4.6.5 Configuration Example
Scenario
Active/standby switchover is required in the current environment. Perform this configuration on the
backup device.
Configuration Steps
Enable the loose TCP status check function on the device.
Ruijie# configure terminal
Ruijie(config)# ip session tcp-loose
Verification
Use the show run command to verify that the configuration includes ip session tcp-loose.
2.4.6.6 Common Errors
-
2.5 Monitoring
2.5.1.1 Clearing Various Information
If you run the clear command while the device is operating, services may be interrupted arising from the loss of
important information.
Function
Command
Clears counters about the IPv4
packets.
clear ip fpm counters
Clears counters about the IPv6
packets.
clear ip v6fpm counters

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English