Configuration Guide Configuring FAT APs
dot11radio interface configuration mode
Configuring E-bag Network Optimization by Using the One-Key Mode
(Optional) There is no default configuration.
If there are no special requirements, you can perform this configuration in the global configuration mode of the AP
equipment.
The items optimized for AP320/AP330/AP3220 and other products are as follows:
(1) Optimization of packet processing at a wired interface: eth-schd 25.
(2) Optimization of wireless aggregation packet re-transmission: ampdu-retries 2.
(3) wifox is disabled.
The items optimized for AP530 are as follows:
(1) sta-idle-time 1800 is used for Radio 1 and 2 by default.
(2) radio 1 optimization: 11b/11g disables the mandatory rates 1, 2, and 5 Mbit/s, and 11g disables the mandatory rates
11 and 24 Mbit/s. ampdu-rts is enabled.
Global configuration mode
This configuration is often used in an e-bag scenario and should be used with caution in other scenarios.
Verification
Run the show running-config command to check the e-bag parameter settings.
Configuration Example
Configuring E-bag Parameters
To Next Page
Loading...
Need help?
General
