Configuration Guide Configuring Syslog
1. Set the level of logs that can be sent to the Console to informational (Level 6).
2. Set the filtering direction of logs to terminal.
3. Set log filtering mode of logs to contains-only.
4. Set the filtering rule of logs to single-match. The module name contains only ARP or IP.
7.2.2 Sending Syslogs to the Log Server
Scenario
Send syslogs to the log server to facilitate the administrator to monitor the logs of devices on the server. The requirements
are as follows:
1. Send syslogs to the log server 10.1.1.1.
2. Send logs of Level 7 or higher to the log server.
3. Send syslogs from the source interface Loopback 0 to the log server.
Figure 7-2 shows the network topology.
Figure 7-2 Network topology
Deployment
Configure the device as follows:
1. Set the IPv4 address of the server to 10.1.1.1.
2. Set the level of logs that can be sent to the log server to debugging (Level 7).
3. Set the source interface of logs sent to the log server to Loopback 0.
7.3 Features
Basic Concepts
Classification of Syslogs
Syslogs can be classified into two types:
Log type
Debug type
Levels of Syslogs
To Next Page
Loading...
Need help?
General
