Configuration Guide Configuring Web Authentication
By default, the first-generation Webauth template is not configured.
Run the web-auth template eportalv1 command in global configuration mode to create the first-generation Webauth
template.
The template is used to implement Web authentication.
 Configuring the IP Address of the Portal Server
By default, the IP address of the portal server is not configured.
Run the ip {ip-address } command in template configuration mode to configure the IP address of the portal server.
Any request packets to access the portal server will be filtered and rate-limited by the NAS.
 Configuring the Webauth URL of the Portal Server
By default, the Webauth URL of the portal server is not configured.
Run the url {url-string } command in template configuration mode to configure the Webauth URL of the portal server.
The URL to which clients are redirected is the address of the Webauth URL provided by the portal server.
 Specifying the Webauth Binding Mode
The default Webauth binding mode is IP-MAC binding mode.
Run the bindmode command in template configuration mode to specify the Webauth binding mode.
In Web authentication on layer-3 networks, the source MAC address in a packet is changed after the packet is routed. In
such case, configure the IP-only binding mode.
 Configuring the Webauth Communication Key
By default, the Webauth communication key is not configured.
Run the web-auth portal key {string } command in global configuration mode to configure the Webauth communication key.
The communication key is used to encrypt URL parameters to avoid information disclosure.
 Enabling Ruijie First-Generation Web Authentication
By default, Ruijie First-Generation Web Authentication is disabled.
Run the web-auth enable command in interface configuration mode to enable Ruijie First-Generation Web Authentication on
the client-connected ports.
After Web authentication is enabled, the unauthenticated clients connecting to a port will be redirected to the Webauth URL.
 Configuring the SNMP-Server Host
By default, the SNMP-server host and community string are not configured.
Run the snmp-server host {ip-address }version 2c {community-string }web-auth command in global configuration mode to
configure the SNMP-server host and community string for Web authentication.
The SNMP-server host is configured to receive Inform/Trap packets of user logout.
To Next Page
Loading...
Need help?
General
