GEN
INFO
CHECKING OF CONNECTIONS
1-4
EB801000
CHECKING OF CONNECTIONS
Check the connectors for stains, rust, moisture,
etc.
1. Disconnect:
•
connector
2. Check:
•
connector
Moisture → Dry each terminal with an air
blower.
Stains/rust → Connect and disconnect the
terminals several times.
3. Check:
•
connector leads
Looseness → Bend up the pin 1 and con-
nect the terminals.
4. Connect:
•
connector terminals
NOTE:
The two terminals “click” together.
5. Check:
•
continuity (using a pocket tester)
NOTE:
•
If there is no continuity, clean the terminals.
•
When checking the wire harness be sure to
perform steps 1 to 3.
•
As a quick remedy, use a contact revitalizer
available at most part stores.
•
Check the connector with a pocket tester as
shown.
To Next Page
Loading...
