AIR FILTER CLEANING
1. Remove:
•
Fast screws (1)
•
Air filter box cap (2)
2. Pull out:
•
Filtering element (3) from its seat
3. Wash:
•
Filtering element (with water and
biodegradable liquid soap)
NOTE:
Rinse properly and dry perfectly by squeezing the
filtering element, without twisting it!
4. Inspect:
•
Filtering element
Damaged ➔ Replace.
5. Apply:
•
SAE 20W50 engine oil or special filter oil
all over filter surface
6. Squeeze out:
•
Excess oil
NOTE:
The filtering element should be wet but not drip-
ping.
3
7. Install:
•
Filtering element (4) in its case
NOTE:
When installing the filtering element in its case, fol-
low the direction indicated by the arrows, make sure
that the flame-trap net is set forward and that the
cap is properly assembled.
8. Reassemble:
•
Air filter box cap
•
Fast screws
Make sure the air filter is properly seated in
the air filter case.
The engine should never be run without the
air filter installed. Excessive piston and/or
cylinder wear may result.
CAUTION:
To Next Page
Loading...
