Rockwell Automation Publication MOTION-UM003K-EN-P - January 2019 123
Configure Integrated Motion Using a PowerFlex 755 Drive Chapter 5
Display Motor Model
Information
The Motor Model dialog box displays more information that is based on the
motor, axis, and feedback configuration types you choose.
• If the motor data source is Catalog Number, the fields are populated
automatically from the database and the fields are read-only.
• If the motor data source is Nameplate data sheet, you can enter the
information.
• If the motor data source is Drive NV, the data comes from the
nonvolatile memory of the drive.
• If you select Catalog Number, Motor NV, or Drive NV, the values
display as read-only.
Motor Analyzer Dialog Box
The Motor Analyzer provides the following three tests:
•Dynamic Motor
•Static Motor
•Calculate Model
The tests analyze motor parameters for rotary and linear induction motors and
permanent magnet motors. The parameters that appear on the tests are
dependent on the motor type you choose.
TIP You can leave the default values, go online, and run a Motor Test to get the
proper values from the drive.
See Hookup Tests on page 226
.
TIP If the motor you are using is a Permanent Magnet, the Dynamic Motor is the
only test that appears.
The asterisk next
to a category
means that you
have not applied
changes.
To Next Page
Loading...
Need help?
General
