Canon imagePROGRAF iPF830 User Manual

Cause Corrective Action
When Detect Mismatch in the Control Pan-
el menu is set to Pause, the type of paper
loaded does not match the type specified in
the printer driver.
1. Press ▲ or ▼ to select Change Paper, and then press the OK button.
2. Replace the loaded paper with paper of the type and size you have specified in
the printer driver.
(See "Loading and Printing on Rolls.") ➔P.18
(See "Loading and Printing on Sheets.") ➔P.20
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quality.
The paper is too small.
The paper is too small.
Cause Corrective Action
When Detect Mismatch in the Control Panel
menu is set to Pause or Hold Job, paper
smaller than the size specified in the printer
driver is loaded.
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quality.
Adjust the paper size setting in the printer driver to match the size loaded in the
printer as follows.
1. Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2. Change the paper size setting in the printer driver to the size loaded in the
printer and try printing again.
Replace the loaded paper with paper of a size that matches the size setting in the
printer driver as follows.
1. Press ▲ or ▼ to select Change Paper, and then press the OK button to stop
printing.
2. Replace the loaded paper to match the settings in the printer driver and try
printing again.
(See "Loading and Printing on Rolls.") ➔P.18
(See "Loading and Printing on Sheets.") ➔P.20
When Detect Mismatch in the Control Panel
menu is set to Warning, paper smaller than the
size specified in the printer driver is loaded.
You can continue to print, but note that this error may cause problems in the print-
ing results.
The paper is too small.
The paper is too small.
"Replace paper with A4/LTR (vertical) or larger"
Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print a test
print sheet or other printer status informa-
tion.)
Replace the paper with paper of A4/Letter (vertical) size or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, press the OK button, and remove the
paper.
(See "Removing Sheets.") ➔P.357
2. Switch to paper A4/Letter (vertical) or larger.
(See "Loading and Printing on Sheets.") ➔P.20
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
PaprWidth Mismatch
PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu is
set to Pause or Hold Job, the width of the loaded roll
does not match the width specified in Fit Roll Paper
Width in the printer driver.
Press ▲ or ▼ to select Print, and then press the OK button to resume
printing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the
printer driver.
iPF830
The paper is too small.
User's Guide
Error Message Messages regarding paper
641

Canon imagePROGRAF iPF830 Specifications

General

Color	Yes
Printing colors	Black, Cyan, Magenta, Matte black, Yellow
Print technology	Inkjet
Maximum resolution	2400 x 1200 DPI
Number of print cartridges	5
Page description languages	GARO, HP-GL/2, HP-RTL
Minimum line width	0.02 mm
Number of power supply units	1
Compliance industry standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3az
Media thickness	0.07 - 0.8 mm
Maximum print size	A0 (841 x 1189 mm)
Maximum roll length	18 m
Media width (sheets)	1117.6 mm
Maximum roll diameter	150 mm
ISO A-series sizes (A0...A9)	A0, A1
JIS B-series sizes (B0...B9)	B0, B2
Display	LCD
Product color	Black, Grey
Storage media	HDD
Internal storage capacity	320 GB
Sound power level (standby)	35 dB
Sound pressure level (printing)	52 dB
USB connector	USB Type-A
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet interface type	Gigabit Ethernet
Power supply	190 W
Power consumption (off)	0.5 W
Power consumption (standby)	5 W
Operating temperature (T-T)	15 - 30 °C
Operating relative humidity (H-H)	10 - 80 %
Sustainability certificates	ENERGY STAR

Weight and Dimensions

Depth	975 mm
Width	1893 mm
Height	1144 mm