Cisco 4500M Command Reference

2-196
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
power dc input
power dc input
To configure power DC input parameters on the switch, use the power dc input command. To return to
the default power settings, use the no form of this command.
power dc input watts
no power dc input
Syntax Description
Defaults DC power input is 2500 watts.
Command Modes Global configuration
Command History
Usage Guidelines If your interface is not capable of supporting Power over Ethernet, you will receive the following error
message:
Power over Ethernet not supported on interface Admin
Examples This example shows how to set the total capacity of the external DC power source to 5000 watts:
Switch(config)# power dc input 5000
Switch(config)#
Related Commands show power
dc input Specifies the external DC source for both power supply slots.
watts Sets the total capacity of the external DC source in watts; valid values are from
300 to 8500.
Release Modification
12.1(11)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(13)EW Support for dc input was added.

Cisco 4500M Specifications

General

Brand	Cisco
Model	4500M
Category	Network Router
Language	English