2-255
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
show dot1x
show dot1x
To display 802.1X statistics and operational status for the entire switch or for a specified interface, use
the show dot1x command.
show dot1x [interface interface-id] | [statistics [interface interface-id]] | [all]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you do not specify an interface, global parameters and a summary are displayed. If you specify an
interface, details for that interface are displayed.
If you specify the statistics keyword without the interface interface-id option, statistics are displayed
for all interfaces. If you specify the statistics keyword with the interface interface-id option, statistics
are displayed for the specified interface.
Expressions are case sensitive. For example, if you enter exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show dot1x privileged EXEC command:
Switch# show dot1x
Sysauthcontrol = Disabled
Dot1x Protocol Version = 1
Dot1x Oper Controlled Directions = Both
Dot1x Admin Controlled Directions = Both
Switch#
interface interface-id (Optional) Displays the 802.1X status for the specified port.
statistics (Optional) Displays 802.1X statistics for the switch or the specified interface.
all (Optional) Displays per-interface 802.1X configuration information for all
interfaces with a non-default 802.1X configuration.
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(19)EW Display enhanced to show the guest-VLAN value.
To Next Page
Loading...
Need help?
General
