2-253
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
show diagnostic result module test 3
show diagnostic result module test 3
To display results from the ongoing packet memory test, use the show diagnostic result module test 3
command. The output indicates whether the test passed, failed, or was not run.
show diagnostic result module N test 3 [detail]
Syntax Description
Defaults Non-detailed results
Command Modes EXEC mode
Command History
Usage Guidelines The detail keyword is intended for use by Cisco support personnel when analyzing failures.
Examples This example shows how to display results from the ongoing packet memory tests:
Switch# show diagnostic result module 1 test 3
Test results: (. = Pass, F = Fail, U = Untested)
3) packet-memory-ongoing -----------> .
This example shows how to display detailed results from the ongoing packet memory tests:
Switch# show diagnostic result module 1 test 3 detail
Test results: (. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
3) packet-memory-ongoing -----------> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 0
Last test execution time ----> n/a
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> n/a
Total failure count ---------> 0
Consecutive failure count ---> 0
packet buffers on free list: 64557 bad: 0 used for ongoing tests: 979
N Specifies the module number.
detail (Optional) Specifies the display of detailed information for analysis.
Release Modification
12.2(18)EW This command was introduced on the Catalyst 4500 series switch.
To Next Page
Loading...
Need help?
General
