Cisco 4500M Command Reference

2-56
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug lacp
debug lacp
To debug LACP activity, use the debug lacp command. To disable debugging output, use the no form of
this command.
debug lacp [all | event | fsm | misc | packet]
no debug lacp
Syntax Description
Defaults Debugging of LACP activity is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is supported by the supervisor engine only and can be entered only from the switch
console.
Examples This example shows how to enable LACP miscellaneous debugging:
Switch# debug lacp
Port Aggregation Protocol Miscellaneous debugging is on
Switch#
Related Commands undebug pagp (same as no debug pagp)
all (Optional) Enables all LACP debugging.
event (Optional) Enables debugging of LACP events.
fsm (Optional) Enables debugging of the LACP finite state machine.
misc (Optional) Enables miscellaneous LACP debugging.
packet (Optional) Enables LACP packet debugging.
Release Modification
12.1(13)EW Support for this command was introduced on the Catalyst 4500 series switch.

Cisco 4500M Specifications

General

Brand	Cisco
Model	4500M
Category	Network Router
Language	English