2-434
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
spanning-tree mst hello-time
spanning-tree mst hello-time
To set the hello-time delay timer for all the instances, use the spanning-tree mst hello-time command. To
return to the default settings, use the no form of the command.
spanning-tree mst hello-time seconds
no spanning-tree mst hello-time
Syntax Description
Defaults The hello-time delay timer is set for 2 seconds.
Command Modes Global configuration
Command History
Usage Guidelines If you do not specify the hello-time value, the value is calculated from the network diameter.
Examples This example shows how to set the hello-time delay timer:
Switch(config)# spanning-tree mst hello-time 3
Switch(config)#
Related Commands show spanning-tree mst
seconds Number of seconds to set the hello-time delay timer for all the instances on the
Catalyst4500 series switch; valid values are from 1 to 10 seconds.
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
To Next Page
Loading...
Need help?
General
