Cisco 4500M Command Reference

2-373
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
show redundancy
show redundancy
To display redundancy facility information, use the show redundancy command.
show redundancy {clients | counters | history | states}
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC
Command History
Examples This example shows how to display redundancy facility client information:
Switch# show redundancy clients
clientID = 0 clientSeq = 0 RF_INTERNAL_MSG
clientID = 30 clientSeq = 135 Redundancy Mode RF
clientID = 28 clientSeq = 330 GALIOS_CONFIG_SYNC
clientID = 65000 clientSeq = 65000 RF_LAST_CLIENT Switch
The output displays the following information:
• clientID displays the client’s ID number.
• clientSeq displays the client’s notification sequence number.
• Current redundancy facility state.
This example shows how to display the redundancy facility counter information:
Switch# show redundancy counters
Redundancy Facility OMs
comm link up = 1
comm link down down = 0
invalid client tx = 0
null tx by client = 0
tx failures = 0
tx msg length invalid = 0
client not rxing msgs = 0
rx peer msg routing errors = 0
null peer msg rx = 0
clients Displays the redundancy facility client information.
counters Displays the redundancy facility counter information.
history Displays a log of past status and related information for the redundancy facility.
states Displays the redundancy facility state information.
Release Modification
12.1.(13)EW Support for this command was introduced on the Catalyst 4500 series switch
(Catalyst 4507R only.)

Cisco 4500M Specifications

General

Brand	Cisco
Model	4500M
Category	Network Router
Language	English