2-402
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
show vlan dot1q tag native
show vlan dot1q tag native
To display all the ports on the switch that are eligible for native VLAN tagging as well as their current
native VLAN tagging status, use the show vlan dot1q tag native command.
show vlan dot1q tag native
Syntax Description This command has no arguments or keywords.
Command Modes User EXEC
Command History
Examples This is an example of output from the show vlan dot1q tag native command:
Switch> show vlan dot1q tag native
dot1q native vlan tagging is disabled globally
Per Port Native Vlan Tagging State
----------------------------------
Port Operational Native VLAN
Mode Tagging State
------------------------------------
f3/2 trunk enabled
f3/16 PVLAN trunk disabled
f3/16 trunk enabled
Related Commands switchport mode
vlan (global configuration) (refer to Cisco IOS documentation)
vlan (VLAN configuration) (refer to Cisco IOS documentation)
Release Modification
12.1(18)EW This command was introduced on the Catalyst 4500 series switch.
To Next Page
Loading...
Need help?
General
