2-61
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug platform packet protocol pagp
debug platform packet protocol pagp
To debug PAgP protocol packets, use the debug platform packet protocol lacp command. To disable
debugging output, use the no form of this command.
debug platform packet protocol pagp [receive | transmit | vlan]
no debug platform packet protocol pagp [receive | transmit | vlan]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC
Command History
Examples This example shows how to enable all PM debugging:
Switch# debug platform packet protocol pagp
Switch#
Related Commands undebug platform packet protocol pagp (same as no debug platform packet protocol pagp)
receive Enables platform packet reception debugging functions.
transmit Enables platform packet transmission debugging functions.
vlan Enables platform packet VLAN debugging functions.
Release Modification
12.1(13)EW Support for this command was introduced on the Catalyst 4500 series switch.
To Next Page
Loading...
Need help?
General
