Kubota WSM L5040-II User Manual

BRAKES
L3540-II, L4240-II, L5040-II, L5240-II, L5740-II , WSM
5-S7
[2] BRAKE CASE
Draining the Transmission Fluid
WARNING
• Be sure to stop the engine before draining the transmission
fluid.
• Allow the engine to cool down sufficiently, oil can be hot
and burn.
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid completely.
4. Reinstall the drain plugs (1).
(When refilling)
• Fill up from filling port after removing the filling plug (2) until
reaching the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the
oil level again, add the fluid to prescribed level if it is not correct
level.
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
(Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-10.)
• Do not mix different brands of fluid together.
9Y1211167CLS0005US0
Transmission fluid Capacity
L3540-II
40 L
10.6 U.S.gals
8.8 lmp.gals
L4240-II
Manual
Transmission
Model
43 L
11.4 U.S.gals
9.5 Imp.gals
L4240-II
HST Model
39 L
10.3 U.S.gals
8.6 Imp.gals
L5040-II
46 L
12.2 U.S.gals
10.1 Imp.gals
L5240-II,
L5740-II
41 L
10.8 U.S.gals
9.0 Imp.gals
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
A: Oil level is acceptable within this
range.
[a] HST Model
[b] GST/Manual Transmission Model
KiSC issued 02, 2015 A

Kubota WSM L5040-II Specifications

General

Brand	Kubota
Model	WSM L5040-II
Category	Tractor
Language	English