ELECTRICAL SYSTEM
L3540-II, L4240-II, L5040-II, L5240-II, L5740-II , WSM
9-S28
(8) Mode "G" (GST Shift Shock Fine-adjustment Mode) Adjusting the Clutch
Engaging Interval
• When the sense of shifting shock is not suitable, shifting
shock can be changed by this adjustment.
1. While holding down the both switches at once, start the engine.
2. Select the mode "G".
3. "SHOCK" is displayed (b) first and then the numerical code
setting is displayed (c).
The number "-9" through "+9" can be displayed. This has been
factory-adjusted to "0".
4. Setting;
• For lighter shifting shock;
Press the travel speed switch to reduce the number
• For higher shifting shock;
Press the display mode switch to increase the number
5. Move the tractor to check the shifting shock.
6. Turn off the key. Then setting will be put in memory.
• If the shift shock has been adjusted but no remarkable
effect can be felt, keep the setting at "0"
9Y1211167ELS0023US0
(9) Mode "H" (Error Information Display Mode) Be carefuling or Reviewing
the Error Information
1. While holding down the both switches at once, turn on the main
switch.
2. Select the mode "H".
3. If there is not error information in memory, "NO ERROR" is
displayed (b).
4. If there is error information in memory, its information is
displayed.
5. If there are two or more error information readouts, presses the
display mode switch and the stored information can be reviewed
one by one.
6. Even if a problem has been corrected or repaired, the
information is displayed until it is deleted.
7. Refer to Mode "D" (Error Information Reset Mode) for deleting
the error information.
9Y1211167ELS0024US0
(a) Mode Selection Display
(b) Information Display
(c) Setting Number Display
(a) Mode Selection Display (b) Information Display
To Next Page
Loading...
Need help?
General