Maintaining Your Machine
129
8
Maintaining Your Machine
If the exposure glass, exposure glass cover, or ADF belt is dirty, copy clarity may
be reduced. Clean these parts if they are dirty.
Important
❒ Do not use chemical cleaners or organic solvents, such as thinner or benzene.
If such substances get inside the machine or melt plastic parts, a failure might
occur.
❒ Do not clean parts other than those explicitly specified in this manual. Other
parts should only be cleaned by your service representative.
❖ How to maintain
Cleaning the machine Wipe the machine with a soft, damp cloth, and then
wipe it with a dry cloth to remove the water.
Cleaning the Exposure Glass
The following procedure describes how to clean the exposure glass and the scan-
ning glass.
Clean 1 and 2.
To Next Page
Loading...
Need help?
General
