Using Connect Copy
149
3
Note
❒ To cancel Connect Copy mode, press [Connect Copy], which is highlighted
on the main machine.
❒ Since the sub-machine starts copying after receiving data from the main
machine, the numbers of copy sets differ on the main and sub machines. If
the transferred data is massive, the difference between the numbers of cop-
ies made by the main machine and sub-machine will increase.
❒ Both machines may not finish copying at the same time.
❒ When using the Sort/Staple function, copying is divided between the two
machines by the number of sets. If a paper misfeed occurs when processing
a set of copes, it is not possible for the other machine to take over the re-
mainder of that particular set.
❒ To interrupt ADF scanning, press the {Clear/Stop} key on the main ma-
chine, and then select [Stop] in response to the message that appears.
❒ To stop copying, press the {Clear/Stop} key on the main machine, and then
select [Stop] in response to the message that appears.
❒ When the memory to store originals exceeds the maximum, an error mes-
sage appears. For details, see “When Memory Is Full”, Troubleshooting.
Reference
p.19 “Batch Mode”
“When the Authentication Screen is Displayed”, About this Machine
“Administrator Tools”, “General Features”, General Settings Guide
“When Memory Is Full”, Troubleshooting
Order of Copy Output
❖ When copying with the Sort/Staple function
(Example) Copying 6 sets of a three-page original
A Main machine (face-down)
B Sub-machine (face-down)
When using the Sort/Staple function, the processing of one copy set cannot
be divided between the two machines.
ANP047S
To Next Page
Loading...
Need help?
General
