173
4. Changing/Confirming
Communication Information
This section explains the features of [Change TX / Info], which you can use to con-
firm communication results on the screen or printed reports.
Changing the Settings of Files in Memory
After you have pressed the {Start} key (after scanning originals), you can check
and edit the destination or settings of Memory Transmission. You can also can-
cel a transmission, change the settings of a transmission, print a stored file, print
a list of stored files, and resend a file which the machine failed to transmit.
Note
❒ If the “No transmission files found.” message appears on the screen af-
ter you press [Check / Stop Transmission File], no files are being stored or sent
by Memory Transmission.
❒ You cannot check or edit a file being sent. Also a SUB Code Transmission file
or stored file to be printed as a report cannot be checked or edited.
❒ There are cases when a destination may not be selected as the destination ap-
pears as “p”, depending on the security settings.
To Next Page
Loading...
Need help?
General
