Viewing Fax Information Using a Web Browser
261
6
Programming Destination Information from Web Browser
If the receiving machine is compliant with T.37 full mode Internet Fax, you can
program the receiver's properties from Web Image Monitor. You can program
the following properties:
• Compression Type
• Paper size
•Resolution
Note
❒ For a detailed description, see Help for Web Image Monitor.
❒ When a receiver that is programmed as full mode in the Address Book re-
turns a Reception Notice e-mail, the contents of the newly received e-mail
overwrite the existing information.
Reference
p.35 “T.37 Full Mode”
To edit machine properties already programmed
Follow these steps to use Web Image Monitor to edit information about the des-
tination machine registered in the Address Book.
A Start the Web browser.
B Enter the IPv4 address of the machine you want to monitor after “http://” in
the address field.
The top screen is displayed.
C Click [Login], and then enter the Administrator's name and password.
D Click [Address Book] in the left pane.
The Address Book is displayed.
E Click the radio button to the left of the machine you want to modify, and
then click [Change].
The [Change User] page appears.
F Set the properties for Internet Fax data format other than the mode selection.
If you change the mode to “Simple Mode”, you cannot set machine properties.
G Click [OK] at the upper-left of the screen.
To cancel the setting, click [Cancel] in the upper-left of the screen.
The Address Book is displayed.
H Close the Web browser.
To Next Page
Loading...
Need help?
General
