Bus setups Set up a MIPI D SI-1 serial bus
To set the speed, click the Speed entry box and select from the drop-down list.
To set the signal type, click the Signal Type entry box and select from the drop-down list.
Behavior
The instrument changes the components, voltage threshold levels, speed, and signal type, and uses those to
decode the selected USB bus.
What do you want to do next?
Learn more about bus setups. (see page 95)
Learn about bus configuration. (see page 148)
Learn about digital setups. (see page 87)
Learn how
to set up an I2C serial bus.
(see page 582)
Learn how to set u p an SPI serial bus. (see page 582)
Learn how to set up a USB serial bus. (see page 584)
Learn how to set up an RS-232 serial bus. (see page 583)
Learn how to set up a MIPI DSI1 Serial Bus (see page 584)
Learn how to set up a MIPI CSI2 Serial Bus (see page 585)
Lear
nhowtosetupan8B10BSerialBus
(see page 111)
Learn how to set up a CAN Bus (see page 115)
Learn how to set up a MIL-1553 Bus (see page 120)
LearnhowtosetupanEthernetBus(see page 121)
Learn how to set up an Custom serial bus. (see page 586)
Learn how to troubleshoot a serial bus. (see page 595)
Le
arn how to view analog characteristics of a digital waveform.
(see page 579)
Learn how to trigger on a bus. (see page 658)
Set up a MIPI DSI-1 serial bus
NOTE. MIPI DSI-1 serial bus setup is available only on instruments with the SR-DPHY option.
From the Bus Setup window in the Config tab, select a bus from the Bus list and then select the MIPI
DSI-1 Serial bus type.
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 107
To Next Page
Loading...
Need help?
General
