Bus setups Set up a PCIe serial bus
Learn how to set up an Ethernet Bus (see page 121)
Learn how to set up a Custom serial bus. (see page 586)
Learn how to track down serial bus anomalies. (see page 590)
Learn how to view analog characteristics of a digital waveform. (see page 579)
Learn how to trigger on a bus. (see page 658)
Set up a PCIe serial bus
NOTE. PCIe serial bus setup is available only on instruments with the SR-PCIE option.
From the Bus Setup window, select Serial from the Bus Type list and then select the PCIe Serial bus type.
For information on the controls, click the buttons.
To use
To change the input for a component, click the Input and select a channel from the cascading lists.
To set the serial bus type, click the Serial Bus Type entry box and select from the drop-down list.
To change the voltage threshold level, click the Threshold entry box and use the keypad to enter a
value or use the multipurpose knobs to select a voltage level.
To change the voltage hysteresis level, click the Hysteresis entry box and use the keypad to enter a
value or use the multipurpose knobs to select a voltage level.
To set the data rate, click the Data Rate entry box and select from the drop-down list.
Behavior
The instrument changes the components and voltage threshold levels, and uses those to decode the
selected bus.
114 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
Need help?
General
