How to ? Localize a measurement
Localize a measurement
Use the following procedure to take a measurement over a segment of the waveform:
1. The instrument must be installed and operating, with a signal connected to an input channel, and
horizontal and vertical controls and triggering set up.
2. Obtain a stable display of the waveform to be measured.
3. From the toolbar, click Measure to open the Measurement Setup control window.
4. Under Setups, click Gating from any tab. The Measurement Gating control window opens.
5. To select h
ow to define the gated area, click one of the following:
Cursor. Sets the gated area to the area between the cursors. Use the multipurpose knobs to adjust
the curso
rs on screen.
Zoom (1–4). Sets the gated area to the waveform area contained in the Zoom (1–4) area.
Off. Turns off measurement gating. You can also turn gating off from the Zoom shortcut menu.
6. If you selected Cursor, you must also select the Track Mode:
Indep. This mode lets you m ove one cursor at a time using the multipurpose knobs.
Tracking. This mode allows you to move both cursors at the same time. The cursors track one
another; moving one cursor moves the other cursor in tandem.
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 605
To Next Page
Loading...
Need help?
General
