Vertical Setups Waveform Label C ontrol Window
Waveform Label Control Window
From the Vertical or Math menus, select Label.
Overview
Use the Label control window to attach a label to the waveform.
To use
1. Use the Channels Selector (see page 258) to select a valid ch
annel, math, or reference waveform.
2. Click in the Label entry box, and then use the pop-up keyboard to create a label for the selected
waveform.
3. Click in the X Position and Y Position entry boxes to activate them.
4. Use the multipurpose knobs to position the label on the graticule. You can also position the label
anywhereonthescreenbyclickinganddragging it to the desired location.
Behavior
The label applies only to the selected w aveform. Ea
ch waveform (channel, math, or reference) can have its
own label. If you do not enter a label for the selected waveform, the label will be left blank. A label only
appears when its associated waveform is turned on.
The X Pos control values are relative to the left side of the display. The YPos control values are relative to
the waveform handle. The values are expressed in divisions.
What do you want to do next?
Learn more about the Vertical controls. (see p
age
487)
Learn more about the Math controls. (see page 241)
Learn more about the Reference Waveform controls. (see page 523)
Vertical Offset Control Window
From the Vertical menu, select Offset.
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 487
To Next Page
Loading...
Need help?
General
