Tektronix DPO70000C/DX Series User Manual

Trigger setups Set up a CAN bus trigger
Trigger on FCS (CRC) Erro r
Select FCS (CRC) Error to trigger on an Ethernet FCS error.
Set up a CAN bus trigger
NOTE. The CAN Bus Trigger type is only available on DPO7000C Series instruments.
From the Trig menu, select CAN Setup.
NOTE. You must install Protocol Trigger and Decode Option(OptPTH)onsomeinstruments before you
can access the CAN triggers.
Over
view
Use the controls in this window to set up the parameters to trigger on a CAN bus.
NOT
E. The CAN bus trigger is only available on analog channels.
To use
For information on the controls, click the buttons.
420 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series

Tektronix DPO70000C/DX Series Specifications

General

Brand	Tektronix
Model	DPO70000C/DX Series
Category	Test Equipment
Language	English