56 Guidelines for planning the cabinet installation
The module can be installed in a cabinet with the following dimensions:
• width 800 mm (31.50 in.)
• depth 600 mm (23.62 in.)
• height 2000 mm (78.74 in.).
Planning the placement of the control panel
Note the following alternatives when you plan the placement of the control panel:
• When the control unit is inside the drive module (option +P905), the control panel can
be integrated in the drive module (option +J414).
• The control panel can be mounted onto the cabinet door using a control panel
mounting platform (options +J410 and +J413). For the installation instructions, refer to
DPMP-01 mounting platform for ACS-AP control panel (3AUA0000100140 [English])
or DPMP-02 mounting platform for ACS-AP-X control panel (3AUA0000136205
[English]).
Planning the use of cubicle heaters
Use a cubicle heater if there is a risk of condensation in the cabinet. Although the primary
function of the heater is to keep the air dry, it may also be required for heating at low
temperatures.
ABB air inlet and outlet kits
See section Cabinet ventilation on page 176.
To Next Page
Loading...
Need help?
General