Rockwell Automation Publication 2711P-UM008I-EN-P - February 2022 85
Chapter 3
Enter Configuration Mode on Startup
To launch FactoryTalk View ME Station in Configuration mode on startup,
follow these steps.
1. Press Terminal Settings, then choose Startup Options.
2. To select Go to Configuration Mode, press On Startup.
3. To view or change optional settings, press Configuration Mode Options.
4. To specify whether you want to load the current application on startup,
press Load Current Application.
5. To specify what configuration settings are used when the loaded
application is run, press Replace RSLinx® Enterprise Communications:
• To use the RSLinx communication settings in the terminal, select
No.
• To replace the terminal settings with the communication settings in
the application, select Yes. Any changes to RSLinx device addresses or
driver properties on the terminal are lost.
6. To return to the previous dialog box, press OK.
7. To return to terminal settings, press OK.
TIP On Series B terminals, the Do not start FactoryTalk View ME Station option is
not available and is grayed out.
(1)
(1) Series C for Stainless Steel terminals.
To Next Page
Loading...
Need help?
General
