Rockwell Automation Publication 2711P-UM008I-EN-P - February 2022 95
Chapter 3
Display Settings
For the terminal display, you can change its brightness, configure the screen
saver, or disable the screen cursor.
Adjust Display Intensity
You can adjust the intensity of the backlight in 10% increments from 0…100%.
At 0%, the backlight is minimally visible. You can use the default intensity of
100% or adjust the intensity for runtime operations.
1. Press Terminal Settings, then choose Display>Display Intensity.
2. To switch between Default intensity and Runtime intensity, press
Startup Intensity.
• If you select Runtime, the start-up screens use the runtime intensity.
• If you select Default, the start-up screens us the default setting of
100%.
3. To increase or decrease the intensity for runtime operations, press the up
or down cursors.
4. To save changes, press OK.
Configure the Screen Saver
A screen saver image appears on the terminal display when no user activity has
been sensed for a certain time. The default idle time is 10 minutes. You can
adjust the idle time and intensity level of the screen saver, disable the screen
saver, or disable the screen saver image.
1. Press Terminal Settings, then choose Display>Screen Saver.
TIP Startup Intensity is not available on Series B terminals (Series C for Stainless
Steel terminals).
TIP Screensaver is not available in the initial Series B release (Series C for
Stainless Steel terminals); it will be added at a later date.
To Next Page
Loading...
Need help?
General
