Transfer: Motor-Shift Type (Transfer with Shift Actuator) 3C-56
7) Apply sealant to thread of level / filler plug, and then
tighten it to specified torque.
“A”: Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Transfer oil level / filler plug (b): 23 N·m (2.3 kgf-
m, 17.0 lb-ft)
Transfer Oil Seal Removal and Installation
S5JB0E3316003
Removal
1) Lift up vehicle and drain transfer oil.
2) Remove front propeller shaft and/or rear propeller
shaft referring to “Propeller Shaft Removal and
Installation: in Section 3D in related manual”.
3) Remove front oil seal No.1 (1) and/or rear oil seal (2)
using flat end rod or the like.
“a”. 0 – 10 mm (0 – 0.394 in.)
I5JB0A331002-03
2
1
I5JB0A331031-01
To Next Page
Loading...
Need help?
General
