xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
330
The fields that can be configured are described below:
Parameter Description
Select the unit to be displayed. (EI and SI Mode Only)
Select a range of ports to be displayed.
Click the Apply button to accept the changes made.
NOTE: The user must first globally enable Authentication Mode in the 802.1X Global Settings
window before initializing ports. Information in this window cannot be viewed before enabling
the authentication mode for either Port-based or MAC-based.
Initialize Host-based Port(s)
This window is used to display the current initialized host-based ports.
To view this window, click Security > 802.1X > Initialize Host-based Port(s) as shown below:
Figure 8-19 Initialize Host-based Port(s) window
The fields that can be configured are described below:
Parameter Description
Select the unit to be displayed. (EI and SI Mode Only)
Select a range of ports to be displayed.
MAC Address
Tick the check box and enter the authenticated MAC address of the client
connected to the corresponding port.
Click the Apply button to accept the changes made.
NOTE: The user must first globally enable Authentication Mode in the 802.1X Global Settings
window before initializing ports. Information in this window cannot be viewed before enabling
the authentication mode for either Port-based or MAC-based.
Reauthenticate Port-based Port(s)
This window is used to display the current status of the re-authenticated port-based port(s).
To view this window, click Security > 802.1X > Reauthenticate Port-based Port(s) as shown below:
Figure 8-20 Reauthenticate Port-based Port(s) window
The fields that can be configured are described below:
Parameter Description
Select the unit to be displayed. (EI and SI Mode Only)
Select a range of ports to be displayed.