3
Basic copy operations
3-70 C300
Basic copy operations Chapter 3
The following procedures describe how to select Finishing settings.
2
Reminder
The Staple settings are available only if the optional finisher is installed.
The Punch settings are available only if the optional finisher and punch kit
are installed.
Separating copies by sets (“Sort” setting)
0 The factory default setting is “Group”.
0 If “Offset” is selected while no finisher is installed, printed copies will be
fed out and sorted in an alternating crisscross pattern if the following
conditions are met.
0 8-1/2 × 11- or 5-1/2 × 8-1/2-size paper is used.
0 Paper of the same size and type is loaded with the w orientation in one
paper tray and with the v orientation in another tray.
0 The “Auto Paper Select” setting is selected.
0 The “Auto Paper Select” setting is not selected when the “Mixed Original”
setting is selected.
0 If “Offset” is selected while a finisher is installed, printed copies are fed
out and stacked on top of each other with each set shifted to separate it.
Staple Select one of these settings to bind the copies with a staple in
the corner or with two staples.
Punch Select this setting to punch holes (2 or 3 holes) in the copies
for filing them.
Finishing Setting Description
1
1
To Next Page
Loading...
Need help?
General
