3
Basic copy operations
3-76 C300
Basic copy operations Chapter 3
Punching holes in copies (Punch settings)
!
Detail
In order for holes to be punched in the copies, all of the following condi-
tions must be met.
- The paper width must be 8-1/2 inch or between 11 inch and 11-3/4 inch
(with the “2-Hole” punch setting).
- The paper width must be between 11 inch and 11-3/4 inch (with the “3-
Hole” punch setting).
- The paper length must be between 7-1/4 inch and 17 inch
If a Punch setting is to be selected, select the orientation in which the
original is positioned. If an Original Direction setting is not selected, holes
may not be punched in the copies as desired.
For details on specifying the original orientation, refer to “Selecting the
original orientation (Original Direction settings)” on page 3-22.
2
Note
The Punch settings are available only if the optional finisher and punch kit
are installed.
Paper Weight Paper Size
13-1/4 lb to 55-1/2 lb 2 holes: 11 × 17 w to 8-1/2 × 11 w/v
3 holes: 11 × 17 w, 8-1/2 × 11 w/v
To Next Page
Loading...
Need help?
General
