Copy paper/originals
7
C300 7-29
Copy paper/originals Chapter 7
Originals that can be placed on the original glass
To copy originals that cannot be loaded into the ADF, position them on the
original glass.
*1
There are five Foolscap sizes: 220 mm × 330 mm w, 8-1/2 × 13 w, 8-
1/4 × 13 w, 8-1/8 × 13-1/4 w and 8 × 13 w. Any one of these sizes can
be selected. For details, contact the technical representative.
Precautions for Positioning Originals on the Original Glass
Observe the following precautions when placing the original on the original
glass.
- The size of originals printed on paper in metric sizes (such as A3, B4, A4)
cannot be automatically detected. The setting must be specified by the
technical representative. For details, contact the technical representa-
tive.
- If an original of non-standard paper size is loaded, the “Auto Paper Se-
lect” and “Auto Zoom” settings cannot be used since the original size
cannot be detected automatically. If an original of non-standard paper
size is loaded, select the size of the paper to be copied.
- If highly translucent or transparent originals, such as OHP or diazo pho-
tosensitive paper, are loaded, the original size cannot be detected auto-
matically. Place a blank sheet of paper of the same size over the original.
- Do not place objects exceeding 4-1/2 lb on the original glass, otherwise
the original glass may be damaged.
- If a book is placed on the original glass, do not press it down extremely
hard, otherwise the original glass may be damaged.
Original Glass Originals
Original type Sheets, books (spreads), three-dimensional objects
Original size 11 × 17 w to 8-1/2 × 11 w/v, 5-1/2 × 8-1/2 w, A3 w to A5
w, 8 × 13 w
*1
Maximum weight 4-1/2 lb
To Next Page
Loading...
Need help?
General
