Basic copy operations
3
C300 3-73
Basic copy operations Chapter 3
Stapling copies (Staple settings)
!
Detail
In order for the copies to be stapled, all of the following conditions must
be met.
- The paper width must be between 7-1/4 inch and 11-3/4 inch.
- The paper length must be between 5-3/4 inch and 17 inch.
If the “Mixed Original” setting is selected, all copies must have the same
paper width.
If a Staple setting is selected, the “Sort” setting is automatically selected.
A Staple setting cannot be used together with the “Offset” setting.
If a Staple setting is to be selected, select the orientation in which the
original is positioned and the orientation of the page to be stapled, oth-
erwise the copies may not be stapled as desired.
For details on specifying the original orientation, refer to “Selecting the
original orientation (Original Direction settings)” on page 3-22.
Copies can be fed out stapled either in the corner or at two places.
Number of Bound Pages
Examples of the possible number of bound pages are listed below.
- 50 sheets of 24 lb paper
- 2 sheets of 55-1/2 lb paper + 48 sheets of 24 lb paper
- Maximum of 30 sheets of 24-1/4 to 40 lb paper
2
Reminder
Copies can be fed out stapled either in the corner or at two places only
when the finisher is installed.
Tray Paper Weight Paper Size Loading Capacity
Finishing tray 1 13-1/4 lb to 24 lb 11 × 17 w to
8-1/2 × 11 w/v
1-1/4 inch
24-1/4 lb to 32 lb
Finishing tray 2 13-1/4 lb to 24 lb 11 × 17 w to
8-1/2 × 11 w/v
A4 w or less: 5-1/4 inch
B4 w or more: 2-1/2 inch
24-1/4 lb to 32 lb
Optional finishing tray 13-1/4 lb to 24 lb 11 × 17 w to
8-1/2 × 11 w/v
1 inch
24-1/4 lb to 32 lb
To Next Page
Loading...
Need help?
General
