12
Utility
12-60 C300
Utility Chapter 12
2
Note
If the angle of the center folding position must be adjusted, contact your
technical representative.
2
Note
Enter the value by mm using the keypad.
Refer to the conversion rate below.
1 in. = 25.4 mm
Adjusting the center stapling position
The stapling position when printing with the “Center Staple” setting can be
adjusted for each paper size and for each paper type.
0 Adjust the center folding position before adjusting the center stapling po-
sition.
0 Before making any adjustments, use the “Fold & Staple” function to print
a single sample copy. Perform the adjustment while checking the sample
that was created.
1 Display the Administrator Setting screen.
– For details on displaying the Administrator Setting screen, refer to
“Displaying the Administrator Setting screen” on page 12-47.
2 Touch [1 System Setting].
The System Setting screen appears.
3 Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4 Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
To Next Page
Loading...
Need help?
General
